Grizzly EXTREME G0513X2B, Manual

Page: 10 / 104

-10-
Model g0513X2B (Mfg. since 5/11)
components and hardware needed: Qty
Fence Assembly ................................................ 1
Front rail .......................................................... 1
rail plates ......................................................... 3
Cap screws M6-1 x 20 ...................................... 3
Flat Washers 6mm ............................................ 3
lock Washers 6mm ........................................... 3
Cap screw M8-1.25 x 20 ................................... 1
Knobs M8-1.25 x 20 .......................................... 2
Flat Washers 8mm ............................................ 4
lock Washer 8mm ............................................ 1
resaw Fence..................................................... 1
lock handle M8-1.25 x 44 ................................ 1
Moving plate ...................................................... 1
to install the fence:
1. Attach the rail plates to the front rail with the
three M6-1 x 20 cap screws, 6mm lock wash-
ers, and 6mm flat washers (see
figure 3).
figure 3. installing front rail onto table.
Knob
Flat
Washer
8mm
Flat Washer 6mm
lock Washer 6mm
lock Washer
8mm
2. Attach the outer two rail plates with the round
and elongated mounting holes on the outer
part of the table bottom with two M8-1.25 x
20 knobs and 8mm flat washers. Attach the
remaining rail plate with the round mounting
holes using an M8-1.25 x 20 cap screw, 8mm
lock washer and 8mm flat washer (
figure
3).
(Replaces Table on
Page 21)
(Replaces Installing
Fence on Page 25)
components and hardware needed: Qty
hex Bolts M8-1.25 x 25 .................................... 4
1. Follow steps 1-3 on page 21 in the g0513X
Manual. if the table insert is pre-installed,
remove it now.
2. With the help of another person, lift the table
onto the trunnions.
3. secure the table to the trunnions with the four
M8-1.25 x 25 hex bolts, 8mm lock washers
and 8mm flat washers.
4. Follow steps 6-9 in the g0513X Manual.
components and hardware needed: Qty
hex Bolts M8-1.25 x 90 .................................... 1
hex nut M8-1.25 ................................................ 1
to install the positive stop:
1. unlock the table tilt lock lever, tilt the table to
access the positive stop bolt installation loca-
tion, then lock the lever.
2. thread the M8-1.25 hex nut halfway onto the
M8-1.25 x 90 hex bolt (this is the positive stop
bolt).
3. thread the positive stop bolt into the thread-
ed hole on the bandsaw body.
4. lower the table onto the positive stop bolt.
5. Follow to set the positive stop on g0513X
Manual page 24.
(Replaces Positive
Stop on Page 23)
Front rail
rail plate
Cap screw
M6-1 x 20
Cap screw
M8-1.25 x 20