70
GB
equipment. Contact between the saw
chain and a live wire can make metal
parts of the equipment live and cause
an electric shock.
• Ensure you have a secure stance during
sawing. Do not work on a ladder, in the
tree or on unstable locations. Be very
cautious carrying out work on a slope.
• Keep your working area tidy. Only start
work if your working area is free from
obstruction and you have planned a
safe path of escape when felling timber.
• Place the claw stop securely with every
cut and do not begin with the sawing
before this.
• Be extremely careful during sawing
small bushes and branches. The thin
branch thicket can snag in the saw and
whip in your direction or make you un-
balanced.
• Do not cut wood that is lying on the
ground.
• Pay attention to a possible spring-back
during the sawing of a branch which is
under stress, if the stress force of the
wood is suddenly released. Danger of
injury exists.
• Check the safety status of the cordless
pruner, in particular the chain bar, chain
brake and the chain, before use.
• In the event that the cutting attach-
ment becomes jammed or stuck in the
branches, do not attempt to free the
equipment with the use of force. Switch
off the equipment immediately and re
-
start it only after clearing the blockage.
There is a risk of injury!
Residual risks
Even if properly operating and handling
this electric tool, some residual risks will
remain. Due to its construction and build,
this electric tool may present the following
hazards:
a) Cuts
b) Ear damage if working without ear
protection.
c) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
Assembly instructions
Turn off the appliance and, before
doing any servicing, remove the
battery.
If the tubes of the device are not
fitted into each other or screwed
correctly, the device cannot be
switched on. A safety switch pre-
vents the operation!
Use only original parts.
Assemble device
1. Interlock the end of the hex-
agonal aluminium pipe of the
telescopic arm (10) and the end
of the arm below the cutting
head (7) up to the stop. Whilst
interlocking the two, ensure that
the nose (10a) of the hexagonal
aluminium pipe fits into the nut
(7a) at the end of the arm (see
small image).
2. Fasten both parts using the
screw sleeve (9)
.
Fitting the saw chain and
blade
Turn off the appliance and, before
doing any servicing, remove the
battery.
Summary of Contents for AKS 1820 T Lion-Set
