PACKING
Check carefully the content of the box and in case of damage contact your forwarder immediately.
The following items are included in the box:
n° 1 instructions leaflet
n° 1 COLORWAY HSR/MSR 1200W
n° 2 XLR 3 poles plugs (1 male + 1 female)
n° 1 power supply plug
SAFETY
Even if this lantern is fitted with a safety micro-switch which automatically disconnects power as
soon as the lamp cover is opened, disconnect the lantern from mains supply before replacing the
lamp.
This projector has been designed for indoor use.
For safety operation, max. ambient temperature must not exceed 50°C.
- Caution: the surface temperature of the projector can reach 120°C.
- Caution: hot lamp; make sure the lamp is cold before attempting to remove it (wait for about 10
minutes).
- Caution: it is strongly recommended that a safety-chain or wire is attached to this projector and
secured to the main mounting framework to arrest the fall of the unit in the unlikely event that the
primary mounting arrangement should fail.
INSTALLATION
Fitting the lamp
1) Open the lamp cover untightening the 2 screws located on the rear part of the lantern and the
one placed on the upper part of the projector body..
2) Clean the lamp with a cleaning towel and fit it carefully into the lamp holder.
Avoid touching the lamp with fingers or dirty towels.
Do not shake the lamp or make it hit the condensor lens or other inner components while fixing it.
3) Secure the lamp to the lamp holder.
4) Close the lamp cover.
