1.0 PACKING
Check carefully the content of the box and in case of damage contact your forwarder immedia-
tely.
The following items are included in the box:
n° 1 instructions leaflet;
n° 1 ACROBAT PE 575;
n° 2 XLR 3 poles plugs (1 male + 1 female);
n° 1 power supply plug;
n°10 additional metal gobos.
2.0 SAFETY
Disconnect the lantern from mains supply before replacing the lamp or servicing the unit.
- This projector has been designed for use in interior: the unit shall be shielded or protected by
ingress of water if used outdoor.
- For safety operation, maximum ambient temperature must not exceed 50°C.
- Caution: the surface temperature of the projector can reach 90°C
- Caution: hot lamp! Make sure the lamp is cold before attempting to remove it: wait for about
10 minutes.
- Caution: it is strongly recommended that a safety-chain or wire is attached to this projector
and secured to the main mounting framework to arrest the fall of the unit in the unlikely event
that the primary mounting arrangement should fail.
3.0 INSTALLATION
3.1 Movement arrest system removal
A pan movement arrest system has been provided in order to avoid damages to the unit during
transport. Move the two arresting knobs before attempting to switch the unit on.
Unfasten the two knobs indicated by the arrows in pictures 1 and 2 and move them to the very
end of the outer profile;
10
pict.1
pict.2
