3.4 Fixing plate
The base of the unit is provided with 6 M10 thread
inserts to allow a steady installation on every single
kind of trussing system as well as on the wall and
on the floor.
Please note that the rubber feet can be removed for
a much more confortable fixing of the unit by its
proper insert.
3.5 Electrical connection
1) Cable the mains plug with a supply cable
3x1.5mm2 (minimum size).
2) Connect the lantern to a mains supply of 230V - 50/60Hz.
3) Make sure the mains supply unit is correctly grounded.
The power line shall be provided with safety switch.
4) ACROBAT FE is fitted with power factor correction.
3.6 Plugs connection
The connection of the XLR 3 poles must be as follows:
pin 1---> function GND (SHIELD)
pin 2---> function SIGNAL -
pin 3---> function
Please make sure the cables are properly connected.
Use shielded cable.
4.0 USE OF THE LANTERN
4.1 Function in DMX standard mode
Make sure the display of the unit is correctly set. The ACROBAT FE unit uses 6 channels (8 chan-
nels when the 16 bit resolution is selected) and the DMX addressing of more units accessed by a
digital controller should be set as per following diagram.
pict 1
DMX Adressing 6 Canali 8 Canali
Projector 1
0 0 1
0 0 1
Projector 2
0 0 7
0 0 9
Projector 3
0 1 3
0 1 7
Projector 4
0 1 9
0 2 5
Projector 5
0 2 5
0 3 3
Projector 6
0 3 1
0 4 1
Projector 7
0 3 7
0 4 9
Projector 8
0 4 3
0 5 7
Projector 9
0 4 9
0 6 5
Projector 10
0 5 5
0 7 3
11
