Coffee Brewers
Grindmaster
®
7
Installation
Model
Description
PBC-1A2
Coffee brewer, single virtual sightglass, air heated shuttle
PBC-2A2
Coffee brewer, double virtual sightglass, air heated shuttle
PBC-1W2
Coffee brewer, single sightglass, warmer shuttle
PBC-2W2
Coffee brewer, double sightglass, warmer shuttle
PBC-1V2
Coffee brewer, single, vacuum shuttle without stand
PBC-2V2
Coffee brewer, double vacuum shuttle without stand
PBC-1VS2
Coffee brewer, single vacuum shuttle with stand
PBC-2VS2
Coffee brewer, double vacuum shuttle with stand
Model Acronym Key
PBC = PrecisionBrew™ Coffee
-1 = One brew head
A = Air heated shuttle
2 = 230 volt
-2 = Two brew heads W = Warmer heated shuttle
V = Vacuum server w/o stand
VS = Vacuum server with stand
RAS = Remote Air warmer stand 2 = 230 volt
RWS = Remote warmer stand
Unpacking Instructions
Carefully unpack the machine and inspect immediately
for shipping damage. The packaging may contain un-
attached parts. Your machine was shipped in a carton
designed to give it maximum protection in normal
handling. It was thoroughly inspected before leaving
the factory. In case of damage, contact the shipper.
NOTICE:
The person installing this appliance is
responsible for ensuring that electric and water
connections meet the requirements of the national
electric code, national plumbing code, and any local
ordinances.
The electrical input connections can be made from
either the bottom conduit hole or the back panel
conduit hole. Plug the unused hole with the hole plug
provided.
The water connection is on the back of the machine.
Mechanical Installation
NOTICE:
This brewer should be installed by a
knowledgeable and experienced commercial
equipment installer.
1. Inspect unit to see if any damage occurred in
shipment.
2. Remove the brewer from the packing material and
attach its legs.
3. Position the brewer on a strong, stable, and level,
table or counter, at least 5 cm away from walls or
other appliances.For safe operation the appliance
must be placed on a stable horizontal surface in a
vertical position.
4. With bubble level, check to see that the brewer is
level on countertop. Check the level front to back
and side to side. Adjust the legs to the correct level.
Water Filtration.
Installing a scale inhibiting water filter at the time of
installing your new beverage machine will both
improve the quality of your beverage and extend the
life of your new beverage machine.
Before connecting your machine to a clean potable
water supply, your installing engineer or water
treatment professional should test the water for
Calcium, Chlorine, Mineral etc. to determine which type
of water filtration is suitable for your machine and the
volume of water you may use.
Your warranty does not cover –
•
Misuse or abuse of the equipment
•
Breakdown of the equipment due to scale or a
scale related cause.
•
Poor water quality
•
Poor, fluctuating or unsuitable water pressure
Water Hook-up
NOTICE:
This equipment must be installed in
compliance with applicable Federal, State and/or Local
plumbing codes having jurisdiction.
This product
requires an approved backflow prevention water
device, such as a double check valve, to be
installed between the machine and the water
supply.
Use new hose-sets. Do not reuse old hose-sets.
Note:
To prevent excessive pressure drop through
water line, use the shortest length water line which will
allow for moving the machine on the counter for
servicing operations. Excessive length of water line will
reduce the flow of water to the machine.
1. The water line enters on the rear of the brewer. Use
the right hand opening for water.
