MD13-MD18
/ Translation of the original instructions
TROUBLE-SHOOTING
PROBLEM
CAUSE
REMEDY
Dashboard OFF with key in “AVV.” (ON) pos.
– Battery not supplying power
– Check connecting cables
– Recharge battery
– Change the fuse
Dashboard ON, but starter motor does not turn over with key in “AVV” (ON) pos.
– Battery not supplying enough power
– Recharge battery
– Start-up go-ahead not given
– Travel lever in stop position
– Disengage blades
– Sit in the driver’s seat
– Check the three safety sensors (seat – blades
engagement - feed lever)
Difficult starting or irregular running of engine
– Carburation problems
– Clean or change the air filter
– Adjust the carburettor (follow engine manual
instructions)
– Deposits or dirt in fuel
– Empty the tank and use fresh petrol
– Check and change the petrol filter if necessary
Starter motor turns over but engine does not start
– No petrol flow
– Check that the choke has been activated (if
engine is cold)
– Check petrol level in tank
– Check wiring of carburettor opening control
– Check petrol filter (and change if necessary)
- Check that the vent on the tank cap is not
blocked
– Fault in ignition system
– Check that the caps of the spark plugs are
correctly fastened
– Check that the electrodes are clean and at the
correct distance apart.
Drop in engine performance during cutting
– Speed too high for cutting height
– Reduce speed
–
Raise cutting deck by a few notches
Uneven cutting
– Cutting deck not parallel to ground
– Check tyre pressure
14
13
Summary of Contents for MD13
