30
We advise the customer to make a note of this additional
information in the spaces below, as it may be useful for the
service department.
PURCHASE DATE ................................................................................
GRILLO DEALER.........................................................................
22.3
Spare parts
It is recommended to use only original spare parts, which are the only
ones that offer safety and interchangeability.
22.4
Warranty
The warranty is provided in the manner and within the limits speciied
by applicable law. The dealer must give the warranty certiicate of the
machine to the end customer, printing a copy of the registration from
the Grillo web site. As far as the engine is concerned, the conditions
provided by the respective Manufacturers apply.
22.5
How to order spare parts
Contact our authorized dealer.
(Indicate the machine’s serial number and the code of the component
to be replaced). The spare parts catalogues are available on line at the
Grillo website. You can consult them by entering the serial number.
23
TRANSPORT WARNINGS
TOW HITCH
The tow hitch is located at the rear of the machine. It can tow compac-
tors, trailers up to
a maximum weight of 200 kg on lat grounds.
lIFTING AND TRANSPORT
If the machine is to be transported on a lorry or trailer, lower the cut-
ting deck, apply the parking brake and secure it properly to the means
of transport using ropes, cables or chains. When lifting, the ropes can
be hooked at the point indicated by the arrow (ig.88). Check that the
crane, hoists and ropes have suficient capacity. The total weight of the
machine is 630 kg.
ig. 88
24
DISPOSAl
Never dispose of used oil, petrol or any other type of pollutant in the en-
vironment! Proper maintenance and correct lubrication help to keep the
machine fully eficient. Contact a recycling centre or your dealer for infor
-
mation on proper disposal.
21
TOWING THE MACHINE WITH THE ENGINE OFF
Caution! To tow the machine with the engine switched off, loosen the
screw on the hydrostatic pump (Fig. 86); use a 16 mm - 5/8” wrench.
Loosen the screw by a maximum of two turns.
ig. 86
CAUTION:
this cancels the effectiveness of the braking de-
vice.
ImpORTANT: hitch the machine at very low speed and for short
distances, 100 m maximum, to avoid damaging the hydraulic pump
or the motor. To restore correct operation of the machine, remem-
ber to tighten the screw again, with a maximum torque of 14 Nm.
22
TECHNICAl ASSISTANCE SERVICE
22.1
Assistance
This manual provides instructions for the use of the mower and for its
ordinary and extraordinary maintenance.
For extraordinary maintenance, for all work requiring technical skills
and expertise, please contact your authorised Grillo dealer.
22.2
Identiication data
If it is necessary to contact an authorised service centre, always provide
them with maintenance information:
Model
Serial number
The machine’s serial number plate is located at the rear of the frame,
above the right-hand wheel (ig.87).
000000
Model
Serial number
ig. 87
