6
INSTALLATION SECTION
Alignment of door sprocket to output shaft of
2.0
(see left)
Mounting the unit
The 2.0 is typically flag mounted below the door drum so that the
opener shaft points toward the door opening and lies beneath the sprocket of the
door drum. For mounting you will need to either secure the opener to the roller
shutter head plate with prepared holes or slots, or use a mounting plate that will
need fixing via a wall angle or similar existing structure.
Note: The eDrive +2.0 is not designed to be installed upside down. The chain
guide must not be repositioned.
It is strongly recommended that a suitably rated lifting strap be used to raise the
opener to a necessary height, shown right. A suitable lifting device should be con-
nected to a secure support beam (or similar) above the door axle.
When assessing and selecting an appropriate mounting location, the
following considerations should be made:
Clear accessible space needed below for safe chain operation
Distance between mounting
plate and door sprocket
Min 15mm - Max 100mm
1
Drive chain
Mounting plate slots allow the chain tension to
be adjusted through vertical movement of the
opener (see right)
Mounting plate
2
Mounting plate slots
3
Clear path for manual chain to hang downward (refer pg 8 image no. 7 & 8)
Distance between ACEM and wall 40 mm
