E39.0.0X.6C-03 Operating instruction T-Logg 100 and T-Logg 100 E page 2 of 6
1 General
The logger
T-Logg 100
and
T-Logg 100 E
are designed as a cost-efficient solution for monitoring temperatures.
It enables an individual programming of the recording time. The last 16,000 measuring values can be stored in the
memory. In addition, the LCD-display indicates both the temperature measured at the moment and the operating
status of the logger.
2 Required
accessory:
The USB interface of your PC is used to program, start and read out the
T-Logg.
For this following accessory is required:
Level
converter
USB 100
or
USB 100 SL
for direct connection to the USB port of the PC,
cable length approx. 1m.
MINISOFT
software (version 7.11 or later / free of charge) to start the logger and read out the logger data.
Notice! It’s also possible to use the T-Logg 100 with the comprehensive software
GSOFT 40K
(version 7.11 or later).
3 Safety
instructions:
This device has been designed and tested in accordance with the safety regulations for electronic devices.
However, its trouble-free operation and reliability cannot be guaranteed unless the standard safety measures and
special safety advises given in this manual will be adhered to when using the device.
1. Trouble-free operation and reliability of the device can only be guaranteed if the device is not subjected to any
other climatic conditions than those stated under ‘Specification’
To protect the battery the max. permissible storage and transport temperature of the device is +85°C.
2. General instructions and safety regulations for electric, light and heavy current plants, including domestic safety
regulations (e.g. VDE), have to be observed.
3. If device is to be connected to other devices (e.g. via PC) the circuitry has to be designed most carefully. Internal
connection in third party devices (e.g. connection GND and earth) may result in not-permissible voltages
impairing or destroying the device or another device connected.
4. If there is a risk whatsoever involved in running it, the device has to be switched off immediately and to be
marked accordingly to avoid re-starting.
Operator safety may be a risk if:
- there is visible damage to the device.
- the device is not working as specified.
- the device has been stored under unsuitable conditions for a longer time.
In case of doubt, please return device to manufacturer for repair or maintenance.
5. Warning:
Do not use this product as safety or emergency stop devices, or in any other application where failure of the
product could result in personal injury or material damage.
Failure to comply with these instructions could result in death or serious injury and material damage!
