E39.0.0X.6C-03 Operating instruction T-Logg 100 and T-Logg 100 E page 3 of 6
4 Connection
■
Assignment of the input jack
(front view to the pins):
Interface [–]
Not connected
Interface [+]
5 Advice regarding state of logger upon delivery:
Upon its delivery the logger is in a kind of 'sleeping state': The display does not show anything, the power
consumption is at its minimum.
The
T-Logg 100
‘wakes up’ as a communication link with a software has been established. After that the message
‘Stop‘ appears at display. The logger is ready for operation now.
6 Operating mode display:
The
T-Logg 100
is equipped with a 10 mm LCD display.
The main purpose of the LCD display is to indicate the temperature. Depending on the operating mode of the
logger, other messages will be displayed as well.
STOP
:
The
T-Logg
is ‘stopped’. No data are recorded. The logger memory is empty.
The logger is reset and can be restarted.
HALT
:
The
T-Logg
has been ‘halted’. The stored data can be read.
The logger memory is not empty.
DISPLAY OF TEMPERATURE
:
The small arrow is flashing The logger is active.
Temperature measurements are carried out at certain intervals. The temperature
measured will be stored.
START DELAY
:
The logger is active, but no data are recorded.
As soon as the start delay time has expired, the logger will start recording in accordance
with the starting conditions programmed before.
START ALARM
:
The logger is active, but no data are recorded. Recording will start as soon as the
temperature is within the min. and max. alarm limits.
