ROTOR ADJUSTMENT
1.
Switch off the engine and wait until all moving parts are motionless. Disconnect the spark plug lead and ensure it
can no longer make contact with the spark plug.
2.
Unscrew the wing handle on the support at the rear of the machine.
3.
Slide the rear section of the rotor in the opposite direction to that in which you want to brush.
4.
Secure the wing handle tightly.
DEAD MAN’S HANDLE ADJUSTMENT
The brush head should stop as soon as the dead man’s handle is released. The operating lead should have sufficient play
when the handle is fully released. If the brush head does not switch off completely when the dead man’s handle is released,
adjust the play in the operating lead as follows:
1. Unscrew the bottom cable nut.
2. Push the guide bush on the cable up in the direction of the dead man’s handle
.
3. Tighten the upper cable nut on the dismantling support to secure the guide bush.
4. Tighten the nuts against the fixing point to lock them in that position.
1.
Operating cable
2.
Operating cable wire
3.
Dead man’s handle
4.
Steering column
5.
Cable nuts
6.
Guide bush
