GreenWorks GACSB, Quick Start Manual

Page: 4 / 9

possible to tie the extension cord and power cord in a
knot to prevent them from becoming disconnected during
use. Make the knot as shown, then connect the plug end of
the power cord into the receptacle end of the extension
cord. This method can also be used to tie two extension
cords together.
• POLARIZED PLUGS To reduce the risk of electric
shock, this product has a polarized plug (one blade is
wider than the other). This product must be used with a
suitable polarized extension cord. Polarized connections
will fit together only one way. Make sure that the
receptacle end of the extension cord has large and small
blade slot widths. If the plug does not fit fully into the
extension cord, reverse the plug. If it still does not fit,
obtain a suitable extension cord. If the extension cord
does not fit fully into the proper outlet. Do not change the
tool plug or extension cord in any way.
NOTE
WARNING: Use outdoor extension cords marked SW-A,
SOW-A, STW-A, STOW-A, SJW-A, SJTW-A, or SJTOWA.
These cords are rated for outdoor use and reduce the risk of
electric shock.
• DISCONNECT UNIT from the power supply when
not in use or when servicing or cleaning. Do not leave
unattended.
• DON’T ABUSE CORD Never carry or pull this product
by the cord or yank the cord to disconnect from the
receptacle. Keep cord from heat, oil, and sharp edges.
• STAY ALERT Watch what you are doing. Use common
sense. Do not operate the garden shredder when you are
tired or under the influence of drugs or medication.
• STORE IDLE UNIT INDOORS When not in use, the
garden shredder should be stored indoors in a dry and
high or locked-up place, out of children’s reach.
• MAINTAIN UNIT WITH CARE Keep clean for best
performance and to reduce the risk of injury. Inspect
extension cord periodically and replace if damaged. Keep
handles dry, clean and free from oil and grease.
• CHECK FOR DAMAGED PARTS Before further use
of the product, any part that is damaged should be
carefully checked to determine that it will operate
properly and perform its intended function. Check for
alignment of moving parts, binding of moving parts,
breakage of parts, mounting and any other condition that
may affect its operation. Any part that is damaged should
be properly repaired or replaced.
• LIGHTING Only operate your garden shredder in
daylight or good artificial light.
• DON’T OVERREACH Keep proper footing and
balance at all times. Wear oil resistant rubber- soled
footwear.
• Never leave a running tool unattended. Turn the garden
shredder off and wait until it comes to a complete stop
before leaving the work area.
• Avoid accidental start-ups. Make sure switch is in off
position before plugging in the power cord.
• USE RIGHT APPLIANCE Do not use this product for
any job except that for which it is intended.
• KEEP CHILDREN AWAY- All visitors, children and
pets should stay at a safe distance from the work area.
NOTE
WARNING: Some dust and debris created by the use of this
tool could contain chemicals known to the State of
California to cause cancer and birth defects or other
reproductive harm. Some examples of these chemicals are: -
chemicals in fertilizers - compounds in insecticides,
herbicides and pesticides - arsenic and chromium from
chemically treated lumber Your risk from exposure to these
chemicals varies depending on how often you do this type
of work. To reduce your exposure, work in a well-ventilated
area and with approved safety equipment, such as dust
masks that are specifically designed to filter out
microscopic particles.
NOTE
WARNING: California Proposition 65: This product
contains chemicals known to the State of California to cause
cancer, birth defects or other reproductive harm.
2.3 SERVICE
• Have your power tool serviced by a qualified repair
person using only identical replacement parts.
This
will ensure that the safety of the power tool is maintained.
• Never service damaged battery packs. Service of
battery packs should only be performed by the
manufacturer or authorized service providers.
3
English
EN