15
Disassembly/Assembly
Disassembly
Tools Required
You will need a #2 Phillips screwdriver.
Workspace Recommendations
A countertop or flat surface is ideal for disassembling/assembling your unit. You will
need 2 ft. x 3ft. of clean, accessible workspace. It is recommended to use a small bowl
or cup to hold any screws so they are not lost during the /assembly process.
Disassembly Instructions
1.
Turn the unit off.
2.
Remove the Power Cord from the wall and rear of the unit.
3.
Clean exterior of unit if necessary (see “CLEANING: Unit Exterior” page 17).
Removing the Rear Cover:
1.
Using your screw driver, remove the Rear Cover Screw
from the
Rear Cover (above
the
Power Cord Port). Place the Rear Cover Screw where you will find it easily during
reassembly.
2.
Squeeze the tabs on both sides of the Rear Cover (where the grooves are) until
they release and tilt the
Rear Cover upwards until the top tab releases. Clean with
compressed air or a damp cloth. Set the Rear Cover
aside.
Removing the Filter Assembly:
1.
Remove Brass Thumbscrews
from the top corners of the
Filter Assembly
.
Place Brass Thumbscrews where you will find them easily during reassembly.
2.
Grasp the top of the Filter Assembly and tilt away from the unit. Clean if necessary
(see “CLEANING: Filter Assembly” page 17) and set the Filter Assembly
aside.
3.
Lift tabs on either side of Filter Assembly
to remove the rim and access the
separate honeycomb, foam and mesh layers.
Removing the Purification Plate:
Grasp the Purification Plate
on the ceramic and gently pull it out of the grooves on the sides.
Clean (see “CLEANING: Purification Plate” page 17) and set the Purification Plate
aside.
Removing the PCO Cell:
1.
Locate the PCO Cell Power Connector
on the right of the rear of the unit almost
halfway up the unit (beside the Purification Plate slot). Squeeze the tabs on the top
and bottom of the PCO Cell Power Connector
and pull gently until free from the
PCO Cell Power Connector Outlet.
2.
Remove the Thumb Nuts
from the
Screw Posts on the right and left below the
PCO Cell. Place the Thumb Nuts where you will find them easily during reassembly.
3.
Gently slide the PCO Cell out of the unit. Clean (see “CLEANING: PCO Cell”
page 17) and set the PCO Cell
aside.
Clean the interior of the unit (see “CLEANING: Unit Interior” page 17).
Removing the Front Grille:
1.
Locate the four Front Grille Screws
in the four corners of the
Front Grille.
Using your screw driver, carefully remove the four Front Grille Screws. Place the
Front Grille Screws where you will find them easily during reassembly.
2.
Remove the Front Grille
carefully to ensure that the
Ionization Needle(in the top
center of the front of the unit) is not damaged. Clean the Front Grille
if necessary
(using compressed air, vacuum cleaner, damp cloth or warm soapy water)
and set the
Front Grille
aside.
3.
Clean the Ionization Needle if necessary (see “CLEANING: Ionization Needle”).
Summary of Contents for GT3000
Page 19: ...19 Notes ...
