12
Copyright © 2011 GreenTech Environmental | All Rights Reserved
Setup & Operation
Initial Setup
Ideal Placement
There are several important factors to consider when selecting a location for your
GT3000:
•
Make sure the location you choose is as far away from the HVAC air return duct
as possible. This will ensure that the purification produced by the GT3000 is
optimally circulated.
•
Place the unit on top of something tall such as a bookcase, a shelf or a mounting
bracket, leaving only 12 to 24 inches between the unit and the ceiling.
•
To ensure the unit works properly, there should be as much space as possible in
front of your GT3000 so that it can efficiently process the air in the area.
•
Never place an operating unit on the floor.
Initial Settings
Before using the unit you will need to find the area (or square footage) of the
environment. To do this accurately, take into account all connected rooms with
open doorways (the purification does not flow readily through closed doors). The
GT3000 can purify up to 3,000 square feet of space.
For example: Suppose you have a 2500 square foot house. The living room is attached
to the kitchen, three bedrooms, the den and a laundry room. The kitchen and three
bedrooms’ doors remain open the majority of the time but the laundry room and den
usually remain closed off from the rest of the house. Together, the laundry room and
den have a combined area of 500 square feet. The area of the environment you would
want to set your GT3000 and purify would be 2000 square feet.
Once you have determined an ideal location for your unit and calculated the area
of the environment:
1.
Connect the Power Cord
to the
Power Adapter
and the
Power Adapter Plug
into the
unit. (Check to be sure your power supply is properly assembled. The Power
Cord should be inserted far enough into the Power Adapter
so that a space of
only about 1/8 in. is left between the widest part of the power cord and the
edge of the
Power Adapter.)
2.
Insert the
Power Plug
into the wall outlet.
3.
Turn the unit on and set it to NORMAL mode (see CONTROLS)
4.
Leave the unit on NORMAL mode for at least 24 hours to begin with.
5.
After 24 hours, set the unit to HIGH mode and set the square footage to
250 square feet.
6.
Gradually increase the square footage setting every 8-12 hours until you
reach the accurate square footage of your area which you calculated in the
beginning steps). Note: Using the purifier at a setting less than the square
footage of the area being treated is acceptable and may be desirable in an
environment relatively free of pollutants.
Summary of Contents for GT3000
Page 19: ...19 Notes ...
