16
Copyright © 2011 GreenTech Environmental | All Rights Reserved
Disassembly/Assembly
assembly
Refer to Tools & Workspace from Disassembly Section
Installing the FRONT GRILLE:
1.
Gently put the Front Grille in place on the front of the unit, being careful not to
damage the
Ionization Needle
at the top center of the front of the unit.
2.
Insert the four
Front Grille Screws one at a time until they are in place, but not
tight. After all four Front Grille Screws are in place, tighten them carefully.
Installing the PCO CELL:
1.
Position the PCO Cell inside the unit so that the two tabs are on the bottom
(and interior side) of the PCO Cell. Ensure the holes in the two tabs fit over the
two
Screw Posts. Screw the Thumb Nuts
onto the
Screw Posts
until they are snug.
2.
Align the PCO Cell Power Connector
to the
PCO Cell Power Connector Outlet
and
insert gently until the tabs at the top and bottom of the PCO Cell Power Connector
snap into place, holding it in the PCO Cell Power Connector Outlet
.
Installing the PURIFICATION PLATE:
1.
Holding the Purification Plate by the ceramic, slowly insert it into the Purification Plate
Slot, ensuring that the Purification Plate
is sliding into the grooves on either side.
NOTE:
About halfway in, the Purification Plate Connectors are parted. Continue
sliding the
Purification Plate
into the
Purification Plate Slot until there is approximately
one inch of the
Purification Plate
remaining outside of the
Purification Plate Slot
and
significant resistance is met. Be careful not to force the Purification Plate
further into
the
Purification Plate Slot
as this could seriously damage your unit.
Installing the FILTER ASSEMBLY:
1.
Hold the Filter Assembly with the larger flat side (where the honeycomb layer of
the filter is visible) facing the interior of the unit. A sticker reading, “Caution:
Reinstall Filter After Cleaning,” is located on the opposite side of the Filter
Assembly. This sticker should be visible when you install the Filter Assembly
.
2.
Insert the bottom of the Filter Assembly into the tabs on the rear of the unit and
then seat the
Filter Assembly on the rear of the unit. (NOTE: If the user fails to
insert the
Filter Assembly into the tabs appropriately, disassembling the unit in
the future could be extremely difficult.)
3.
Screw the two Brass Thumbscrews
into their holes at the top corners of the
Filter Assembly
.
Installing the Rear Cover:
1.
Place the tab at the top of the Rear Cover
into the hole at the top of the
Filter
Assembly
then lay the
Rear Cover flat against the rear of the unit until the tabs on
the sides of the
Rear Cover click into place on the unit.
2.
Carefully insert the Rear Cover Screw
into its hole on the
Rear Cover (above the
Power Cord Port) and tighten.
Installing the POWER CORD:
1.
Insert the
Power Adapter Plug
into the rear of the unit.
2.
Ensure the Power Cord
is properly connected to the
Power Adapter
.
3.
Insert the
Power Plug
into a wall outlet.
Turning the unit on:
1.
Press the power button.
2.
The unit will be set to Normal Mode once again. Ensure that the unit’s settings are
adjusted to suit the environment (see “Operations” on page 13).
Summary of Contents for GT3000
Page 19: ...19 Notes ...
