Greenlee Textron / Subsidiary of Textron Inc.
12
4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070
555BAT™ Battery-Powered Bender
Preparation (cont’d)
6.
Allow the batteries to charge for approximately
one hour.
7.
Unplug the charger’s power cord.
8.
Use the battery gauge switch to select Battery #1
and Battery #2. When the batteries are at full
charge, the bender is ready to use.
Note:
The charger must be unplugged when
checking the battery charge level.
Using the Battery Gauge and Battery Gauge Switch
4.
Tilt the top of the bender back to expose the battery
compartment. Remove the wire ties and connect the
red cable to the positive (+) terminal and the black
cable to the negative (–) terminal. Connect the black
negative cable last.
5.
To protect the battery cables from damage, place
the excess wire into the space between the batteries
and the side of the battery compartment.
BATTERY 2
BATTERY 1
DECAL NO. 500 5143.1
EMPTY
FULL
% OF CHARGE
BATTERY GAUGE
Connecting the Cables
Red Cable to
Positive Terminal
Black Cable to
Negative Terminal