20
H6200B / 42247 Chain Saw
Greenlee Textron / Subsidiary of Textron Inc.
4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070
Troubleshooting (cont’d)
Tool inoperative.
Tool connected to improper power
See Tool Specifications for type of
source hydraulic system.
hydraulic system required. Verify
power source hydraulic system.
No hydraulic fluid in system or fluid
Check fluid level. Fill to FULL mark.
level low.
Check system for leaks.
Incorrect hydraulic fluid viscosity.
Use fluid viscosity recommended.
See Recommended Hydraulic Fluids.
Tool components loose.
Tighten component hardware.
Dirt, contaminants, etc., in tool
Disassemble tool and clean
components.
components.
Tool components worn or damaged.
Disassemble tool. Replace worn or
damaged components.
Tool operates erratically.
Hydraulic fluid cold.
Viscosity of oil may be too high at
start of tool operation. Allow oil to
warm to operating temperature.
Actuating tool intermittently will
reduce time required to warm oil
to an efficient operating temperature.
Air in system.
Check pump suction line for damage
or loose clamps. Tighten clamps or
replace components if necessary.
Fill reservoir.
Tool components sticking or
Check for dirt or gummy deposits.
binding.
Clean components. Check for worn
or damaged components. Replace
components.
Dirt, contaminants, etc., in tool
Disassemble tool and clean
components.
components.
Tool operates slowly.
Power source components not
Refer to power source operator’s
adjusted correctly.
manual for recommended speed,
flow, and pressure settings.
Hydraulic fluid cold.
Viscosity of oil may be too high at
start of tool operation. Allow oil to
warm to operating temperature.
Actuating tool intermittently will
reduce time required to warm oil
to an efficient operating temperature.
Hydraulic fluid level low.
Check fluid level. Fill to FULL mark.
Check system for leaks.
PROBABLE CAUSE
PROBLEM
POSSIBLE REMEDY
