52
TROUBLESHOOTING
The table includes some of the most common problems, their causes and remedies.
PROBLEM
POSSIBLE CAUSE
SOLUTION
Ignition
failure
• Incorrect fuel.
• Fuel filter is clogged.
• Carburetor adjustment screw out of
normal range.
• Spark plug is dirty / electrode gap not
correct.
• Spark plug disconnected.
• Remove and use the correct fuel.
• Clean fuel filter.
• Adjust the carburetor adjustment screw to
normal range.
• Clean/dry spark plug properly (distance
0.6-0.7mm).
• Retighten the spark plug.
Engine starts
but stops /
is difficult to
restart
• Incorrect or stagnant fuel.
• Carburetor adjustment screw out of
normal range.
• Coal accumulates in muffler, cylinder
(exhaust port).
• Dust block in air filter.
• Dust block on cylinder fins, fan cover.
• Remove and use correct fuel.
• Adjust the carburetor adjustment screw to
normal range.
• Clean the muffler immediately.
• Wash the air filter.
• Clean the cylinder fins, fan cover.
NOTE:
In the event of not being able to resolve the problem, get in touch with an Official Technical
Service.
TRANSPORTATION AND STORAGE
•
If transporting the machine on a bumpy road, drain the fuel first.
•
Do not use the machine when in a vehicle. Remove the machine from the vehicle and use it in a well-ventilated
area.
•
Avoid leaving the vehicle in sunlight when using the machine. If the machine is left in a locked vehicle for many
hours, high temperatures inside the vehicle can cause the fuel to evaporate and cause a possible explosion.
•
Wait 5 minutes after turning off the engine before transporting the machine.
•
Transport the machine with the motor switched off and the blade guard installed.
•
Store this tool in a safe, dry place with temperatures between 0º and 45ºC.
•
Wait for the machine to cool before storing.
•
To reduce the risk of fire, keep the engine, muffler and fuel tank clean by removing cut material, oil and grease.
•
Before storing the machine for a long period of time, ensure that the storage area is free of excessive moisture
and dust.
•
Store the machine out of the reach of children and where fuel vapor does not come into contact with flames or
sparks.
•
For long periods of storage, store the machine without fuel. The stored fuels must be stabilized with a stabilizer.
Remove the spark plug and pour about 3cm3 of oil into the cylinder through the hole in the spark plug. Slowly
slide the recoil starter 2 or 3 times so that the oil can cover the inside of the engine and replace the spark plug.
Summary of Contents for 1000090
Page 2: ......
Page 68: ...www greencut es Manual revisado en mayo de 2019 ...
