CIP 1500 – User and Maintenance Manual
16
YANMAR
MOTOR
A
D
C
B
Chapter
9
START
-
UP
MACHINE START-UP (version with self-contained drive)
CAUTION!
The starter key of the machine has to be kept by the operator
whenever the machine is stopped. Leaving the key in the control
panel involves a risk for starting by a third party.
Start the machine by following the procedures specified in the Handbook
specifically dealing with the engine.
INSTALLATION (version with three-point linkage)
CAUTION!
Check the slope grade of the cardan shaft to be 30° as a
maximum.
Connect the machine to the 3-point linkage
of the tractor. Plug into safety sockets
(B,C,D).
Connect the cardan shaft to both power
take-off of the tractor and input shaft of the
machine
(A).
Verify the check pins have tripped.
NOTE: While rotating, the angle of
inclination of the cardan shaft has not
to exceed 30°. Check that its minimum
endplay is 10 cm (G).
Verify the direction of rotation
(R)
Lock the tractor by engaging the parking
brake. If the machine is equipped with “No-
Stress” device, connect its cable to the 12V
battery.
Slowly start the tractor running up to reach
the rate required (max. 540 r.p.m. ).
HONDA
MOTOR
G
A
D I R E C T I O N O F R O T A T I O N
ANGLE UNIT
INPUT SHAFT
TRACTOR PTO
R
