EN
Programming With Push Buttons
When to switch off devices after the area is vacated
To learn proprietary infrared commands
Press the Time button
to
set the time to wait before
switching off devices in the
circuit (default 20 minutes). The
number of presses sets the time:
# Presses
Time
1
10 seconds
2
5 minutes
3
10 minutes
4
20 minutes
5
30 minutes
ON:
1. Press
once to get the device ready to learn the air con
ON command. This Learn mode is active for 10 sec.
2. Point the air conditioning controller at the device and send the
ON command, as described by the manufacturer's instructions.
If the command has been correctly learnt, the LED in the
device flashes slowly; if not, it flashes quickly.
OFF:
1. Press
twice to get the device ready to learn the air
conditioning OFF command. This Learn mode is active for 10
seconds.
2. Point the air conditioning controller at the device and send the
OFF command, as described by the manufacturer's
instructions. If the command has been correctly learnt, the LED
in the device flashes slowly; if not, it flashes quickly.
To find the current Time setting
Press and hold the Time button
for more than 3 seconds.
The number of LED flashes
indicates the setting:
# Flashes
Time
1
10 seconds
2
5 minutes
3
10 minutes
4
20 minutes
5
30 minutes
To test the device has learnt the commands
To lock the programmed settings
l
Press and hold
for more than 3 seconds. The air con will
turn on if the ON commands has been correctly programmed.
l
Press and hold
for more than 3 seconds again. The air
conditioning will turn off if the OFF commands has been
correctly programmed.
Press and hold either button
or
for more than 10
seconds to toggle between lock and unlock. This locks the sensor
if the LED lights up while pressing the button. This unlocks the
sensor if the LED doesn't light up but flashes once after 10
seconds.