Dry Contact & 24 Volt Adaptor
13
contact signals are disappeared, the corresponding dry contact signal LED
will be off and keep the off status. The unit can be turned on.
NOTE!
If the adaptor is completely shielded (locked), dry contact and fire signal will be
invalid. When the fire alarm or dry contact signal is detected, the operation of the wire
controller and remote controller is disabled.
4.4.4 Parameter Setting
Unit parameters can be set under on or off status.
(1) Press “ENTER” button to enter into parameter setting page. The nixie tube
displays “P00”.
(2) Press “UP” or “DOWN” button can select parameter code. Press “ENTER”
button to switch to parameter value setting and the nixie tube flashes to
display the parameter value. Press “UP” or “DOWN” button can adjust the
parameter value and then press “ENTER” to complete the setting and
return to previous level.
(3) Press “BACK” button to return to previous level.
NOTE!
After entering the parameter setting state, there will be no operation in 20s, and
the parameter setting state will be exited.
Unit parameters setting list is shown as below:
