Gree GWC36LB-D1NNA2A/I, Service Manual

Page: 18 / 74

15
Function and Control
ON/OFF :
MODE :
+
:
FAN :
1
2
4
3
5
Press this button to start the unit operation .Press this button again to stop the unit operation.
Each time you press this button,a mode is selected in a sequence that goes from AUTO,
COOL,DRY, FAN, and HEAT
*
, as the following:
AUTO COOL DRY
FAN HEAT
*
*Note:Only for models with heating function.
After energization, AUTO mode is defaulted. In AUTO mode, the set temperature will not
be displayed on the LCD, and the unit will automatically select the suitable operation
mode in accordance with the room temperature to make indoor room comfortable.
Press this button to decrease set temperature.Holding it down above 2 seconds rapidly
.
decreases set temperature. In AUTO mode, set temperature is not adjustable.
Press this button to increase set temperature.Holding it down above 2 seconds rapidly
increases set temperature. In AUTO mode, set temperature is not adjustable.
This button is used for setting fan speed in the sequence that goes from AUTO,
to then back to Auto.
,
,
,
Auto
Low speed
Medium speed High speed
:
6
Press button to start or stop up & down swing function.The remote controller
defaults to simple swing condition.
Press + button and button at the same time at unit OFF to switch between
simple swing and static swing, blinking 2 seconds.
In static swing condition, press
If the unit is turned off during swing operation,the louver will stop at present position.
button, the swing angle of up & down louver
changes as below:
●
●
●
●