❏ ❏ ❏ ❏
6. Locate one of the knurled knobs and an
8-32 x 2" [51mm] threaded rod.
❏ ❏ ❏ ❏
7. Insert the knurled knob into the opening on
one end of the “I” strut.
❏ ❏ ❏ ❏
8. On each end of the “I” strut, cut the covering
from the hole and insert the threaded rod into the hole in the
bottom of the strut, threading the rod into the knurled knob.
(The threaded rod should slip easily into the strut. If not, drill
through the hole with a 5/32" [4mm] drill bit). Thread the rod
into the knob until the threaded rod is flush with the face of
the knob.
❏ ❏ ❏ ❏
9. Carefully apply a couple of drops of thin CA
to the threads of the rod and knob. This is best done with a
micro tip on the bottle of CA. Only a couple of drops are
required to satisfactorily bond the rod and knob together.
❏
10. Repeat steps 6-9 for each of the knurled knobs and
threaded rods, completing the assembly for each of the
openings in the “I” struts.
❏
11. Glue a 1/8" x 1" [3 x 25mm] dowel into each of the
holes in the bottom of the “I” Struts. Approximately 3/8"
[9.5mm] of the dowel should extend from the strut.
❏
12. On the top of the bottom wing and the bottom of the
top wing you will find two pin holes located approximately 9"
12
