20
❏
9. Test the motor for proper operation. If the motor does
not spin in the correct direction, unplug two of the motor
wires from the ESC and swap the position of the two wires.
Test the motor once again to confirm.
Warning:
Do not install
the propeller until you have performed this check and have
determined that the motor works properly.
❏
10. If you have a 72MHz radio system, route your antenna
through the antenna tube.
❏
11. Route the Y-connector(s) through the cabin floor
panel. Hold the panel in place against the pre-installed rails
and drill six 1/16" [1.6mm] holes into the rails using the holes
in the floor panel as guides. Install the cabin floor using six
#2 x 3/8" sheetmetal screws and six #2 flat washers.
COWL & PROPELLER INSTALLATION
❏
1. Cut out the center of the dummy engine to allow access
for the prop adapter. Use a rotary tool with a sanding drum
to smooth the edges.
❏
2. Pushrod tubes are provided for you if you choose to
detail the dummy engine. Drill a hole in the bottom of the
rocker cover and a corresponding hole in the crank case using
a 3/32" [2.4mm] drill. To start the hole, use your hobby knife
and poke a small “starter hole” to keep your drill centered.
❏
3. Install the aluminum pushrod tubes from the inside.
Glue them in place.
