UT3030-UT5052
Operating Instructions
Great Plains
| 576-026M-A | 05/11/2021
23
Parking
Follow these steps when parking the implement for periods of
less than 36 hours. For longer periods, see
Storage
, the next
topic.
1. Position the implement on firm, level ground.
Negative Tongue Weight Hazard
:
If rear tow hitch is installed it is possible that the Series I
Ultra-Till can tip over backwards during hitching and
unhitching resulting in severe injury or death.
Refer to Figure 15
2. Remove jack from storage position and pin securely to
lifting stob on outside of implement tongue (1). See
Hitching Tractor to Ultra-Till
3. If ground is soft, place a wide block or plate under the
jack to increase contact area.
4. Un
-
hook electrical lines and protect with any plugs or
caps provided.
5. Release pressure on hydraulic system, then disconnect
hydraulic lines and pull all lines back onto implement
tongue. Store hose ends in keyholes of hose holder
bracket.
6. Disconnect the safety chain.
7. Unhitch from tractor or leading implement.
Storage
Store the implement where children do not play. If possible,
store inside for longer life.
1. Raise, fold and lock implement. For unfolded storage, see
steps at right.
2. Perform Parking checklist above.
3. Lubricate the implement at all points listed under
4. Check all bolts, pins, fittings and hoses. Tighten, repair or
replace parts as needed.
5. Check all moving parts for wear or damage. Make notes
of any parts needing repair or replacement before the next
season.
6. Lubricate all points listed in Maintenance to prevent rust.
7. Clean Ultra-Till of mud, dirt, excess oil and grease.
8. Grease exposed cylinder rods to prevent rust.
9. Use touch-up paint to cover scratches, chips and worn
areas to prevent rust.
Figure 15
Front Jack (Parking)
43181
1
Unfolded Storage
1a. Raise implement.
1b. Verify the transport locks are in the transport position.
1c. Be sure hydraulics are de-pressurized. Adjust locking valves to
the open position. Unfold wings until wing is resting on shims.
1d. Lower implement onto lock channels.
1e. Set all hydraulic remotes to Float.
