UT3030-UT5052
Preparation and Setup
Great Plains
| 576-026M-A | 05/11/2021
15
Hitching Tractor to Ultra-Till
Crushing Hazard:
Do not stand or place any body part between Ultra-Till and
moving tractor. You may be severely injured or killed by being
crushed between the tractor and Ultra-Till. Stop tractor engine
and set parking brake before attaching cables and hoses.
To prevent soil compaction on rows, set tractor wheels
between rows. For hillsides and steep slopes, set tractor wheels
as wide as possible for maximum stability.
1. Raise tractor three-point arms (if equipped) clear up to
clear Ultra-Till.
2. For TWO-WHEEL DRIVE and MFWD tractors, pin
drawbar in fixed center position for field and transport.
For FOUR-WHEEL DRIVE and TRAC-DRIVE tractors,
leave one hole clearance on each side of drawbar for field
position, hitch damage may occur if pinned solid. Pin in
center position for transport to maintain maximum
steering control.
3. Hitch the tractor to the Ultra-Till using the block or yoke
clevis determined by the tractor drawbar.This machine is
equipped with a reversible single tang hitch. Use the
correct size hitch pin to insure proper performance and to
minimize wear.
Load Sway Hazard:
Lock drawbar swing to center position to minimize any side-to-
side sway to assure proper tracking in the field, and safe road
, for safe
transporting
Refer to Figure 3
4. Use jack (1) to raise and lower Ultra-Till tongue.
Refer to Figure 4
5. After hitching tractor to Ultra-Till, store jack on storage
tube (2) on top of hitch strut.
6. Secure Ultra-Till safety chain to an anchor on the tractor
capable of pulling the unit.
Figure 3
Tongue on Jack
43184
1
2
Figure 4
Jack in Storage
43182
