GREAT PLAINS SPARTAN II, Operator'S Manual, Page: 81 / 131

Great Plains | 166-486M | 2020/10/08 74
Spartan
II
607 Table of Contents Index Maintenance
Hopper Lid
There are four pivot points and one swivel point on
each hopper lid that requires a multi-purpose oil
lubricant seasonally. Coat each point thoroughly.
Seasonally inspect each hopper lid seal. Inspect if air
leaks are detected. Replace if missing, torn,
permanently compressed, or otherwise damaged.
Do not tightly close lids for extended periods.
Meter Door Seals
Inspect each meter door seal seasonally.
Inspect if air
leaks are detected. Replace if missing, torn, permanently
compressed, or otherwise damaged. Do not tightly close
meter doors all the way for extended periods.

Unloading Hopper Materials
Unloading materials has the same risks as loading
material. Review the instructions on page 48.
Entrapment and Rapid Suffocation Hazard
Never enter a hopper for loading or
unloading.
Possible Chemical Hazard
Agricultural chemicals can be dangerous,
including treatments on seeds, and
components of fertilizers. Improper use can
seriously injure persons, animals, plants,
soil and property.
Unloading Procedure
1. Unless using an auger for unloading, position the
drill on a clear flat surface. Put the tractor in park.
If using an auger, unloading is a two-person
operation.
2. Shut off the tractor unless using the tractor
hydraulics for auger operations.
3. Place a tarp or the auger inlet under the metering
hoses (1) at the rear of the drill.
4. Locate the calibration diverters (2) for the
metering hoses. Slide the calibration diverters to
the open position. Seed will exit out the metering
hoses.
5. Start the tractor engine. Operate the fan and put
the monitor in calibration mode.
6. If using an auger, have everyone stand clear, and
test the auger controls.
7. Locate the yellow button (3) on the left-hand side
of the machine near the ladder (4). Squeeze the
yellow button and the collar under the yellow
button and pull them out approximately 16 mm.
The yellow button is now in the ON position.
Expect material to flow in significant volume until
the hopper is empty. Inspect the hopper from the
lid to confirm that it is empty.
31156
31157
38298
!
!
2
1
38406