GREAT PLAINS PL5700, Operator'S Manual

Page: 64 / 150

Great Plains | 411-681M | 04/08/2021 57
PL5700 Planter Table of Contents Index Operation
AccuShot Fertilizer System (Option)
The optional AccuShot Fertilizer System allows
precision liquid fertilizer application during planting.
For system operation, refer to the AccuShot manual
supplied with the AccuShot option package.
Fertilizer Section Control System (Option)
The optional VisaGage II System allows for section
control, refer to the VisaGage II manual supplied with
the VisaGage II option package.

Parking
Roll-Away Hazard
There is not enough weight on parking stands
to anchor planter on a slope. Do not unhitch
planter while on a steep slope. Always block
tires when unhitching from tractor.
Follow these steps when parking the planter for
periods of less than 36 hours. For longer periods,
see “ Storage ” on page 70.
1. Position the planter on firm, level ground.
2. If installed, fold markers.
3. If equipped with fertilizer, flush the system and
protect the pump against corrosion.
4. Fold the planter.
5. To prevent rolling, block the tires securely.
6. If the ground is soft, place a board or plate under
each stand to increase contact area.
7. Remove the pins (1) and position the parking
stands in the parking position. Insert the pins.
8. Lower the tractor 3-point until the planter is
resting on the parking stands.
9. Set all implement hydraulic circuits to float to
relieve pressure in the lines.
10. Shut down the hydraulics and unplug the
hydraulic lines from the tractor. Do not allow hose
ends to rest on the ground. Protect ends from
contamination.
11. Unplug the light harness and console harness.
Protect the connections with any plugs or caps
provided.
12. Unhitch the planter from the tractor.

Transport
Loss of Control Hazard
Never tow an implement that weighs more than
1.5 times the weight of the tractor. Using an
inadequate tow vehicle can result in loss of
control, serious injury, and death.
Excessive Speed Hazard
To prevent serious injury or death, do not exceed
20 mph (32 kph) maximum transport speed. Loss
of vehicle control and/or machine damage can
result.
Planter Damage Risk
When the planter has been configured with the
weight transfer system, if using any other
equipment for transport other than a suitable
tractor, install shipping links to prevent planter
damage during transport.
The planter can be transported with a full material
load, but the added weight increases stopping
distance and decreases maneuverability. Follow these
instructions when transporting the planter over
roadways. If the planter will be transported or shipped
on a trailer, see “ Trailer Shipping ” on page 124.

Transport only with markers folded.

Verify the planter is securely hitched to a sufficient
tractor.

Unload seed hoppers before transporting if possible.

Transport the planter only in the folded position.
Ensure all four lift cylinder locks are in place and not in
storage location.

Transport the planter only if the wing hooks are
engaged on the tongue stop.

If any seed is in the hoppers or delivery hoses, close
the seed inlet gates at the seed meters.

Check that tires are properly inflated.

Plan the route. Avoid steep hills.

Verify that the lights operate correctly. Always have
lights on for highway transporting.

Comply with all national, regional, and local safety
laws when traveling on public roads.

Remember that the planter is wider than the tractor.
Allow safe clearance.

Transport slowly over uneven or rough terrain.
!
TP-71113
1
1
!
!
!