3P1006NT
Assembly
Great Plains | 151-144U | 2019/03/14
67
3. Route the harness along the frame mount to the
bolt-on frame mount.
4. Place two 3/4 inch hose clips (3) around the
harness. Install one hose clip to the bolt-on frame
mount with a 3/8 x 1-1/4 inch bolt (4), flat
washer (5), and lock washer (6). Route the
harness along the parallel arms and install the
other hose clip to the pivot mount.
5. Use a wire tie to connect the wiring harness to
the mounting post (8) for the SMV.
6. On the left-hand side, route the short wire with
two pin connector (9) to the license plate light.
7.
On both sides, route the wires with the three pin
connectors (10) to the red lights. Route the wires
with the two pin connectors (11) to the amber
lights.
8. Secure the wiring harness with cable ties.
Wire Damage Risk
Make sure all harnesses are secured to
machine. To prevent damage to harnesses,
do not stretch wires and do not let wires drag
on the ground. Allow enough harness length
for operation and watch for any pinch points.
!
3
4
5
6
7
3
8
9
10
11
10
11
71028