24
3.2 Placing an Emergency Call
To place an emergency call on your
JUST IN CASE
TM
911 Emergency Phone,
follow these instructions:
1. Press and hold the 911 Activation Button until you feel and hear it “click.”
2. Continue to press the 911 Activation Button for two seconds to place the
phone call to the 911 emergency operator.
3. After you hear a dial tone indicating the call is in progress, release the 911
Activation Button.
4. When the phone call to 911 has been activated and you hear a dial tone
followed by the three digits (9-1-1) being dialed, the Signal Test LED Light
will be
SOLID GREEN
.
5. BUSY SIGNAL: If you hear a busy signal, release the 911 button and
repress it. This will hang up the call. Try to place another emergency call
by repeating steps 1-4.
NOTE: The
JUST IN CASE
TM
Handset is a speaker phone. Therefore, once
you have placed an emergency call, you should NOT put the Handset
next to, or very close to, your ear or mouth.
When you Press the 911 Activation Button and the phone call fails:
1. The Signal Test LED Light will be
SOLID RED.
2. You will not hear a dial tone.
3. You will hear the audio message “Call failed. Please check connection.”
The phone call may have failed for the following reasons:
1. The Handset is not within range of the Base Unit.
2. The phone line is disconnected from the Base Unit and/or the phone
jack in the wall.
3.3 Failed Emergency Call
