3
To change the lamp of the floodlamp, first removed the unit from the water. Take off the decorative ring and invert it so that the
insertion points on the Decorative Ring (Nº 7) match the insertion points on the Bayonet Ring (Nº 6). Turn counter-clockwise.
(See the arrows on the decorative ring marked OPEN-CLOSE) (Fig 4).
The lamp can be changed without dismounting the Reflector (Nº 2) (Fig 5)
VERY IMPORTANT:
To change the lamp, always use the plastic protector. Never touch the lamp with your bare hands (Fig 5). To
mount the floodlamp, proceed in the opposite order of that described.
Attention:
•
Before any handling ensure that there is NO voltage supplied to the floodlamp.
•
The new lamp should have the same characteristics as that supplied with the floodlamp (75W) 12 V halogen lamp.
•
In order to ensure full watertightness clean the seat of floodlamp lens joint (nº 4) or replace this if any permanent deformation or
notches are visible.
6. START-UP
Ensure that the voltage the lamp receives is never greater than 12 V.
The floodlamp should only operate underwater while secured to the vertical walls of the pool. Never switch on the floodlamp if it is
not underwater.
7. SAFETY WARNINGS
•
The persons who are in charge of assembly should have the required qualifications for this type of work.
•
Avoid making contact with the electric voltage.
•
Comply with the current standards regarding accident prevention.
•
In this regard, the IEC 364-7-702 standards must be observed:
•
WIRING IN BUILDINGS. SPECIAL WIRING. SWIMMING POOLS.
•
Any operation related to the maintenance or replacement of parts should be performed with the floodlamp disconnected
from the electric power system.
•
Do not handle with wet feet.
GUARANTEE CERTIFICATE
1. GENERAL
TERMS
1.1. In accordance with these provisions, the seller guarantees that the
GRE
product corresponding to this guarantee (“the
Product”) is in perfect condition at the time of delivery.
1.2. The Guarantee Term for the Product is two (2) years from the time it is delivered to the purchaser.
1.3. In the event of any defect in the Product that is notified by the purchaser to the seller during the Guarantee Term, the seller
will be obliged to repair or replace the Product, at his own cost and wherever he deems suitable, unless this is impossible or
unreasonable.
1.4. If it is not possible to repair or replace the Product, the purchaser may ask for a proportional reduction in the price or, if the
defect is sufficiently significant, the termination of the sales contract.
1.5. The replaced or repaired parts under this guarantee, will not extend the guarantee period of the original Product, but will have
a separate guarantee.
1.6. In order for this guarantee to come into effect, the purchaser must provide proof of the date of purchase and delivery of the
Product.
1.7. If, after six months from the delivery of the Product to the purchaser, he notifies a defect in the Product, the purchaser must
provide proof of the origin and existence of the alleged defect.
1.8. This Guarantee Certificate is issued without prejudice to the rights corresponding to consumers under national regulations.
2.
INDIVIDUAL TERMS
2.1. This guarantee covers the products referred to in this manual.
2.2. This Guarantee Certificate will only be applicable in European Union countries.
2.3. For this guarantee to be effective, the purchaser must strictly follow the Manufacturer’s instructions included in the
documentation provided with the Product, in cases where it is applicable according to the range and model of the Product.
2.4. When a time schedule is specified for the replacement, maintenance or cleaning of certain parts or components of the
Product, the guarantee will only be valid if this time schedule has been followed.
3. LIMITATIONS
3.1. This guarantee will only be applicable to sales made to consumers, understanding by “consumer”, a person who purchases
the Product for purposes not related to his professional activities.
3.2. The normal wear resulting from using the product is not guaranteed. With respect to expendable or consumable parts,
components and/or materials, such as batteries, light bulbs, etc. the stipulations in the documentation provided with the
Product, will apply.
3.3. The guarantee does not cover those cases when the Product; (I) has been handled incorrectly; (II) has been repaired,
serviced or handled by non-authorised people or (III) has been repaired or serviced not using original parts.
3.4. In cases where the defect of the Product is a result of incorrect installation or start-up, this guarantee will only apply when said
installation or start-up is included in the sales contract of the Product and has been conducted by the seller or under his
responsibility.
