GB - 37
Check Hydraulic Oil Level
MX20114
1. Clean area around dipstick cap (A).
2. Remove dipstick cap (A). Wipe dipstick clean.
NOTE: Do not tighten dipstick cap when checking oil level.
3. Insert dipstick in filler neck (B). Do not tighten cap.
4. Remove dipstick. Check oil level on dipstick. Oil level should
be between the ADD and FULL marks on dipstick.
• If oil level is below ADD mark, fill to proper level.
• If oil level is above FULL mark, drain to proper level.
5. Insert dipstick. Tighten cap.
Check Engine Oil Level
1. Lift thigh pad.
MX12833
2. Clean area around dipstick cap (A).
3. Remove dipstick cap (A) from tube. Wipe dipstick clean.
NOTE: Do not tighten dipstick cap when checking oil level.
4. Insert dipstick in tube. Do not tighten cap.
5. Remove dipstick. Check oil level on dipstick. Oil level should
be between the ADD and FULL marks.
• If oil level is below ADD mark, fill to proper level.
• If oil level is above the FULL mark, drain to proper level.
6. Insert dipstick. Tighten cap.
Connect Battery
MX20124
1. Connect positive (red) cable to battery positive (+) terminal.
Install red terminal cover (A).
2. Connect negative (black) cable to battery negative (-) terminal.
Install black terminal cover (B).
Check Mower Deck Level
The mower deck is assembled and adjusted at the factory. After
machine is completely assembled, check the mower front-to-rear
and side-to-side deck level.
Check Machine Safety Systems
Perform safety system check to make sure the electronic safety
interlock circuit is functioning properly.
ASSEMBLY
WARNING: AVOID INJURY. Read and understand entire
Safety section before proceeding.
CAUTION: Avoid injury! Prevent Battery Explosions:
Keep sparks, lighted matches, and open flame away from the
top of battery. Battery gas can explode.
Never check battery charge by placing a metal object across the
posts. Use a volt-meter or hydrometer.
Do not charge a frozen battery; it may explode. Warm battery to
16 degrees C (60 degrees F).
