GB - 16
NOTE: The pumps (A) are located in the back of the machine,
behind the rear shield (B).
MX20094
2. Turn both pump free-wheel valves (C) counterclockwise
approximately one full turn (open position).
3. Unlock park brake.
4. Push machine to desired location. Due to hydraulic system
drag, machine will move slowly.
5. Turn pump free-wheel valves (C) on both pumps one full turn
clockwise (closed position). Tighten valves to 11 N•m
(100 lb-in.).
6. Lock park brake.
Transporting Machine on a Trailer
Use a heavy-duty trailer to transport your machine. Trailer must
have signs and lights required by law.
1. Raise mower deck to the transport position.
2. Drive machine onto a trailer.
3. Stop engine and lock park brake.
4. Remove key.
5. Fasten machine to trailer with heavy-duty straps, chains or
cables. Both front and rear straps must be directed downward
and outward from machine.
Mowing Tips
• Mow grass with throttle lever in the full fast position.
• Cut grass when it is dry.
• Keep mower deck and discharge chute clean.
• Mow with sharp blades.
• Properly level mower deck for a smooth cut.
• Mow grass high and often.
Use a travel speed that fits the conditions:
• Mow tall or wet grass twice. Cut grass at half desired height –
then cut at desired height.
• Travel slow when mowing tall, thick or wet grass.
• Avoid damaging grass by slipping or skidding machine drive
wheels. Practice smooth control lever movements.
• When performing sharp turns, do not allow inside machine
drive wheel to stop and twist on grass.
Mowing Travel Speeds
Use slow travel speeds for:
• Slopes.
• Trimming.
• Close quarters.
• Tall grass.
Use faster travel speeds for:
• Normal mowing on level ground.
• Dismounting to Inspect Mower
1. Park machine on a hard, level surface.
2. Disengage PTO.
3. Move motion control levers to the neutral position.
4. Lock park brake.
5. Stop engine and remove key. Wait for mower blades to stop
turning before leaving operator’s position.
Service Intervals
Servicing Your Machine
Please use the following timetables to perform routine maintenance
on your machine.
Servicing Engine
See engine manufacturer’s owner’s manual provided with your
machine for engine service information.
Break-In (After First 10 Hours)
• Check air pressure in tires.
• Check wheel bolt torque.
• Check and adjust park brake.
• Change engine oil and filter.
• Check mower deck drive belt tension.
• Check hydraulic pump drive belt.
• Check transmission neutral adjustment.
CAUTION: Avoid injury! Use extra care when loading or
unloading the machine into a trailer or truck.
• Close fuel shut-off valve, if your machine is equipped.
CAUTION: Avoid injury! Help prevent serious injury.
Keep hands and feet away from blades and the discharge
opening.
• Do not step on either side of the mower deck when
mounting and dismounting the machine. Mount and
dismount the machine using the front foot plate.
MAINTENANCE SCHEDULE
WARNING: AVOID INJURY. Read and understand entire
Safety section before proceeding.
IMPORTANT: Avoid Damage! Operating in extreme conditions
may require more frequent service intervals:
• Engine components may become dirty or plugged when
operating in extreme heat, dust or other severe conditions.
• Engine oil may lose efficiency if vehicle is operated
constantly at slow or low engine speeds or with frequent
short trips.
