21
English
21
21
Installation Step 4 (installation of the RC components)
The outer motors are connected in parallel and attached in opposite directions. Please act according to the
circuit diagram. Pay attention to the direction of rotation of the motors when the battery is connected, the
drives should rotate so that the model would go forward.
Install the battery with velcro in the model.
NOTE:
Due to the velcro you can change the position of the batte-
ries easy to achieve the optimum trim. The batteries are typically placed in front of the block of four engines.
Place a ballast in the hull if necessary. Are suitable for this particular flat sections of steel or lead. Trim the
model and fix the ballast weights with adhesive. TIP: If you mount the ballast weights with Velcro, you can
find it if required (eg ease of transport). TIP: To re-retrieve the correct position of the weights without the
trims, you should mark the position with waterproof ink pen.
Mount the receiver under the cover and the speed controller left and right to the hull by means of Velcro.
Speed controller
central motor
To receiver
Motor
Motor
Motor
Speed controller
Motor outer
motors
Servo Y-lead, 3936.11
Drive battery
Drive battery
B
B
Drive battery
A
A
Graupner/SJ THEODOR HEUSS
Receiver
1
Servo Y-lead for speed controllers
Rudder servo
7
2
6
Stern flap winch
