20
Installation and operating instructions
Tools and recommended accessories for installation
Installation Step 1 (Model unpack)
Unpack the model carefully. Loosen with scissors carefully remove the retaining straps. Then pull the model
carefully from the packaging, and then remove all foam parts.
Installation Step 2 (boatstand assemble)
First, you should mount the ship stand, this is
located at the ends of the package behind the
foam. Add together the four halves and glue
them.
Installation Step 3 (Check the screw)
Check the screws on the shaft coupling, the motor mounting bracket and the propeller on a firm seat, as
these might have come loose during transport if necessary. You can check this by pulling on the propeller,
the shaft should be pull out to the rear, is one of the set screws loose. Then pull it back gently laid.
IMPOR-
TANT:
Back up any loose set screws with thread lock, eg UHU security screws (Order No. 952), as they
may become loose due to vibration during operation. The grub screws are loosened with the longitudinal slot
screwdriver, hold the shaft with a flat nose pliers firmly to avoid slipping.
pliers
Phillips Screwdriver PH2 (Order No. 5779.2)
Flat-bladed screwdriver 2.0 (Order No. 5781.2)
- scissors
- pliers
- Phillips Screwdriver PH2 (Order No. 5779.2)
- Flat-bladed screwdriver 2.0 (Order No. 5781.2)
- High-performance grease Order No. 570
- High-performance oil Order No. 206,
- Screws securing Order No. 952
scissors
grease
English
Graupner/SJ THEODOR HEUSS
