Manual Module M-G2 33302
02
3. INSTALLATION MX-SERIES
2
.
Undo the retaining screws and remove the transmitter’s back panel.
3. Now drill a hole about 5 mm in diameter in the
transmitter case, precisely in line with the ope-
ning in the transmitter module case (Fig. 2).
Carefully remove all rough edges from the
hole. Re-attach the transmitter back panel,
fi
t-
ting the aerial connector through this hole.
Fig. 2
Fig. 3
4. The module can now be installed in the trans-
mitter: ensure that the connector contacts are
correctly positioned, otherwise they could be
damaged when you plug the module in; do not
use force! The aerial connector can now be in-
serted in the socket on the module using no
more than light pressure. Ensure that it enga-
ges fully, i.e. there must be no chance of it co-
ming loose when the system is operating (Fig.
3).
5. Now all you have to do is re-attach the module
cover: engage the two lugs on the underside of
the module case, then
fi
t the two screws to se-
cure it. Check that it is correctly located (Fig.
4).
JOB DONE!
Fig. 4
22 mm
1. Open the M-G2 module by undoing the two
screws on the underside. Open up the cover by
folding it downward.
Abb. 1
Fig. 1
