14 / 20
S1012_GR-12L_DE_V1sh
With this RSSI signal and a
flig
ht control board with OSD, e.g. No.
48377, the signal strength of the receiver can be displayed in video
goggles or monitors.
Adjustment range: OFF, CH8, CH12, CH16
F.RESET
A
ft
er changing the value
field
to "Yes" and then pressing or tapping
on the ENT key, or equivalent, a factory reset of the receiver is per-
formed.
Display "MIXER"
RX FREE MIXER
MASTER CH: 0
SLAVE CH: 0
TRAVEL–: 100%
: 100%
MIXER: 1
TRIM: 0%
Up t
o fi
ve mixers can be programmed in the receiver.
MIXER
In the "MIXER" line, select one of mixers 1 … 5.
The following se
ttings
in this display only relate to the mixers selected
in the "MIXER" line.
MASTER CH
In this line the MASTER CH (signal source or source channel) has to
be selected.
Selection
range: (CH)1 … (CH)6
If no mixer has to be set, select "0".
SL
AVE CH
In this line, select the SLAVE CH (signal source or source channel) to
which the signal of the MASTER CH (source channel) is pr
oportion
-
ally mixed.
The level of mixing is determined by the percentages entered in the
"TRAVEL–" and "" lines.
Selection
range: (CH)1 … (CH)6
If no mixer has to be set, select "0".
TRIM
Analogous to the trimming of the control
functions
1 ... 4, the neu-
tral
position
of the mixer in the range of ± 30% can be trimmed in
this line.
TRA
VEL –/+
With the se
ttings
of these two lines, the percentage of mixing is
specified
in rela
tion
to the MASTER signal separately for both direc-
tions.
