68
It is used to program the sensors related with voice function. The default article REPEAT, TRIG,
VARIO, TRANSSMITTER, RECEIVER are available and the optional sensors could be attached.
If the optional sensor is connected, it is need to add the function for the optional sensor at SEN-
SOR SELECT mode then VOICE TRIGGER article is created. The useable sensors are GENER-
AL MODULE, ELECTRIC AIR MODULE, VARIO MODULE, GPS, AIR ESC.
- REPEAT
You may set the time and switch and if the switch is on, one of voice functions is repeated for the
setting time. Press DOWN buttons to go to VOICE TRIGGER line and press ENT button then the
default value 10sec on REPEAT is highlighted. Press UP/DOWN buttons to set the desired value
and press ENT button to remove the highlight. Press the direction button to highlight the hyphen
mark then press ENT button. The popup message “push desired switch into position on” is ap-
peared. Operate the switch to be used as REPEAT on/off, that switch is designated as REPEAT
on/off. After all process, REPEAT function is operated when the switch is on.
19. VOICE TRIGGER
ENT
ESC
TEL
VIW
ENT
ESC
TEL
VIW
ENT
ESC
TEL
VIW
press
It shows RF status between transmitter and receiver through telemetry function.
Press DOWN button to go to RF STATUS VIEW line and press ENT button to access to RF
STATUS VIEW mode. You may check RF status at this screen.
ENT
ESC
TEL
VIW
18. RF STATUS VIEW
ENT
ESC
TEL
VIW
ENT
ESC
TEL
VIW
ENT
ESC
TEL
VIW
press
ENT
ESC
TEL
VIW
press
press
press
press
Summary of Contents for HOT TG/mz-12
Page 75: ...No S1002...
