Special notes
1. If you
fi
nd that the model’s nose constantly turns in one direction, turn the trim knob in the
opposite direction until the rotation ceases.
2. When the transmitter cells are almost exhausted, the LED starts
fl
ashing red. This is the time to
change the batteries.
3. The helicopter can be operated on three different channels (A, B or C). Select the channel,
switch the transmitter on, then switch the helicopter on; if the LED on the circuit board in the
fuselage lights up, you can start
fl
ying
l
Flying the model
1. Set the channel select switch on the transmitter to channel A, B or C as required.
2. Switch the transmitter on: the LED lights up green.
3. Switch the helicopter on (ON): after approx. 5 seconds the helicopter is ready to
fl
y.
4. Keep the blue dome of the transmitter pointing at the helicopter at all times.
5. Place the model on a
fl
at
fl
oor, and check once more that there are no people, animals or
other obstacles close by.
6. Slowly move the throttle stick forward: the helicopter lifts off and climbs.
7. If necessary, turn the trim knob to trim the helicopter, then use the sticks to control the mo-
del.
Operating Instructions Nano Fighter Gyro
18