6
GR-18_Copter_jh_V1
Ð
Protect the receiver from dust, dirt, moisture and other for-
eign parts. Do not expose this equipment to vibration and
excessive heat or cold. The remote control operation may
be carried out only in “normal” ambient temperatures, in a
range from -10 ° C to +55 ° C.
Ð
Use all of your HoTT components only with the latest soft-
ware version.
Ð
If any questions arise that can not be ascertained with the
help of the operating manual, please contact us (contact
information, see page 3) or another expert.
WARNING
Pay attention, even while programming, that the connected
motors do not start suddenly. Injury risk by the turning pro-
pellers!
Avoid shock and pressure. Check the receiver regularly for
damages to the housings and cables after every flight. Dam-
aged or wet electronic components, even if re-dried, should
no longer be used.
Installation in the model (Copter)
The receiver must be placed in line with one side of the Cop-
ter, secure it to the receiver holder. The lower surface of the
receiver must always be parallel to one of the copter sides.
Put some double-sided tape on the bottom of the receiver
and use the optimal double taped pads S8376 for Gr-18,
S8377 for Gr-24 PRO.
Binding
The binding is only possible if the receiver has not yet been
binded to another transmitter (red LED blinks). Pushing the
SET button the receiver will be set in Bind mode.
If you want to bind an already binded receiver to another
memory, follow the next steps:
Ð
Turn off the RF module in the “Basic setting“ menu (see
transmitter’s manual)
Ð
Switch on the receiver pushing the SET button to bring it in
bind mode
Ð
Start the binding in the “Basic setting“ menu
Ð
If within 10 seconds the red light turns off and the green
LED will light, the binding process was successful.
Ð
Your RC system is now ready for use.
Ð
If the red LED is still on it means that the binding process
didn’t work properly. In this case repeat the procedure.
!
