GRASS GRASS ECOPRESS, Operating Instructions Manual

Page: 57 / 84

7-404 Drilling the Front for Grass Zarge System 6000/7000
Illustration 7-404-01/02
Required Equipment:
- 2 (1) drill bit, diameter, Ø 10 mm, right
- (1) drill bit, diameter, Ø 10 mm, left
- Clamping capacity for 32 mm hole distance
Machine Set-Up:
- Turn off the main switch on the motor
- Take off the gearbox cover.
- Remove all existing drill bits, including fastening screws, from the gearbox.
- Fasten new drill bit firmly in the gearbox, see chapter 7-201.
- Spindle placement, see illustration 7-401-01.
- Hang in gearbox cover.
- Adjust the boring depth, if necessary. See chapter 7-301.
- Adjust the boring distance, if necessary. See chapter 7-302.
- Adjust the boring speed of the Ecopress-Pneumatic, if necessary. See chapter 7-303.
- Adjust the turn-on timing of the electric motor, if necessary. See chapter 7-304/305.
- Adjust the side stops only on the right side. See chapter 7-306/307309.
The distance between the first and the second side stop is:
13 mm + bottom width of System 6000
15 mm + bottom width of System 7000
- Adjust the hold down clamping device, if necessary. See chapter 7-308.
- Turn on the main switch. The Ecopress is now ready to operate.
Operating the Ecopress-Pneumatic:
- Place the workpiece on the machine table with one hand pressed against the stops on the fence and against
the first right side stop.
- Clamp the workpiece in the hold down clamping device, if available.
- Press the start button with the second hand until the drilling cycle is complete.
- Place the workpiece against the second right side stop.
- Press the start button with the second hand until the drilling cycle is complete.
Operating the Ecopress-Manual:
- Place the workpiece on the machine table with one hand pressed against the stops on the fence and against
the right side stop.
- Press the hand lever downward with the second hand until the drilling cycle is complete.
- Place the workpiece against the second right side stop.
-Press the hand lever down with the second hand until the drilling cycle is complete.
Caution:
While the machine is being operated: Keep hands clear of the danger area of the hold down clamp, the insertion
arm and the drill gearbox. The safety information in chapter 2 is to be followed whenever the machine is operated.
57
7. Operating the Ecopress
The star in your cabinet