Installing the EDR Boards
PDR 100 Fibre Channel Installation
55
Installing the EDR Boards
See Figure 17 to distinguish between the Master EDR board and the Slave EDR
board, where the Master EDR contains the i960 Controller. See Figure 14 for slot
IDs and Figure 18 for an example of installing a full size board. To install the EDR
boards, proceed as follows:
1. If you have a 2-channel PDR 100, start at step 5, otherwise continue to step 2.
2. Slip the Slave EDR board into the board slide at the front of the board area
for slot J13 aligning it with the edge-board connectors in the motherboard at
the bottom panel and the rear panel cutout for J13.
3. Ensure that the board contacts are correctly aligned with the motherboard
connectors and firmly press down on the board until it is fully seated. Screw
holes in the board bracket should align with the two bracket mounting screw
holes, one on the inside and one on the outside of the rear panel.
4. Use the Torx tool with the T15 bit to secure the Slave EDR board bracket to
the rear panel with the two screws previously removed, but do not fully
tighten until after the PCI Interconnect board has been installed.
5. Slip the Master EDR board into the board slide at the front of the board area
for slot J14 aligning it with the edge-board connectors in the motherboard at
the bottom panel and the rear panel cutout for J14.
6. Repeat step 3 and 4.
