GRASS VALLEY LDK 300, User Manual

Page: 62 / 82

Operating instructions | Managing files 4-22
4. Point two small white boxes at the intended surface.
5. Press the Select button (13) to start the measurement procedure (the iris is set
to Auto). The process running message appears:
6. When the process is completed (within a few seconds) the OK message
appears in the viewfinder.
7. Adjust the skin contour level with the
VIDEO\SKIN\SKIN LEVEL
item.
Decrease the value below 50 to soften the selected area. Increase the value
above 50 to add extra contour.
Repeat the steps for the other memory position if required. Both skin contour settings
can be used at the same time. Set the menu item
VIDEO\SKIN\VIEW
to on to
indicate the effected area.
4.8.9 Classic mode
The
VIDEO
menu allows you to adjust many parameters for setting up detail (contours)
and gamma. If you wish the contour and gamma controls to be the same as in previous
cameras (LDK 100 or LDK 200), then switch to the Classic mode in the Install menu.
4.9 Managing files
You can have access to 15 different files. This number can be extended by using
additional scene file camera cards. The Files menu is used to recall and store these files.
There are two types of file:
• scene files
• operator files
A scene file contains values related to the picture performance. The operator file
contains values related to the set-up of the camera (viewfinder, lens and installation
parameters). The tables in the Appendix indicate the functions that are stored in the
scene file and those functions that are stored in an operator file.
4.9.1 Scene files
Four scene files are stored in the camera itself (SCAM1,SCAM2, SCAM3 and SCAM4).
Another four scene files can be stored on the camera card (SCARD1, SCARD2,
SCARD3 and SCARD4). A STANDARD scene file (preselected as either factory or
customer defined) is stored in the camera.
ND/RE
BATT
TAPE REC ++
+
-
!
AW2 AW1 FL 7.5 5.6 3.2
ASKIN: running