9
Kaleido-RCP2
Guide to Installation and Operation
When you change the DHCP mode, the device must be restarted for the new option to take
effect. This is done automatically but only after you exit the
Configuration
menu. You can
make other changes using the
Configuration
menu, and only exit, once you are done with
the changes.
Configuring Unicast IP Addresses
The unicast IP feature enables a Kaleido-RCP2 to find up to three Kaleido systems on
different subnets and connect to them (via network gateways), while maintaining
Action
LCD indication
Other Buttons
Press and hold the ENTER button
until the ESC button lights up to
access the
Configuration
menu.
Configuration
ROOM SELECTION
Digit keys
2
(UP) and
8
(DOWN), and the
ENTER and ESC
buttons are lit; other
digit keys are dimmed.
Press 8 once to go to the
ETHERNET
OPTIONS
submenu.
Configuration
ETHERNET OPTIONS
Press ENTER to open the Ethernet
parameter menu.
ETHERNET OPTIONS
DHCP
Press 8 to go to the next option in
the menu. (Press 2 to return to the
previous option.)
ETHERNET OPTIONS
IP ADDRESS
Press ENTER again to select this
option and display the current IP
address.
You can move the cursor to the next
digit position by pressing the
space
key.
Use the DEL key to move the cursor
back to the previous position.
IP ADDRESS
010.000.003.191
The cursor blinks, alternating
between a black square and the
digit.
All digit keys are lit as
well as the ENTER, ESC,
DEL and space
key.
Use the digit keys to change the
current value. Once you pressed a
digit key, the cursor moves to the
next position.
IP ADDRESS
192.168.000.010
The cursor blinks, alternating
between a black square and the
digit.
When done, press ENTER to confirm
the address, or ESC to cancel the
change and go back to the previous
menu level.
ETHERNET OPTIONS
IP ADDRESS
All buttons are
dimmed.
Press ESC twice to exit the
Configuration
menu.
Note:
If you changed any of the
network parameters (IP address,
subnet mask or gateway), the
Kaleido-RCP2 unit will reboot.
RMC
(the current room)