GRAPHTEC CUTTING PRO FC2250-120ES, Service Manual

Page: 150 / 210

FC2250-UM-251-9370 8-24
8. ELECTRICAL ADJUSTMENTS
8.14 Adjusting the Registration Mark Sensor Sensitivity
(1) Set the SW1 DIP switch as shown below and then turn on the plotter.
Set bits 4, 5, and 6 to OFF
1 2 3 4 5 6 7 8
ON
OFF
(2) Press the [NEXT] key until the LCD displays the following:
MARK ADJUST
PRESS ENTER KEY!!
(3) Place white paper for adjustment use on the panel, making sure that no part of it is raised above the
surface. The paper color must be white, and it is recommended that high-quality paper made for ink-jet
printers be used.
(4) Press the ENTER key to display the menu shown below.
LEV ADJ DRY TIME
POS ADJ
(5) Press the [F1] key to display the menu shown below.
MOVE TO ADJ. POINT
PRESS ENTER KEY!
Move the mark sensor by the position keys to the position exactly above the paper.
(6) Press the ENTER key to start the registration mark sensor gain adjustment. The plotter immediately
adjusts the registration mark sensor gain automatically.
0 X 50% 100%
(7) The plotter displays the menu shown below when this adjustment has been completed.
LEV ADJ DRY TIME
POS ADJ
(8) Turn off the plotter and then return the DIP switch to its normal settings.