GRAPHTEC CUTTING PRO FC2250-120ES, Service Manual

Page: 30 / 210

FC2250-UM-251-9730 3-6
3. OPERATIONS
3.4 Adjusting the Pen Carriage Height
Initial adjustment of the pen carriage height
Insert the plate up to the position
where this hole can still be seen
(1) Use the hexagon wrench to loosen the height adjustment bolt.
(2) When the pen carriage can be moved freely up and down, insert the height adjustment plate (thick)
under the pen carriage. Adjust the height of the pen carriage so that the pen carriage rests on top of the
plate.
(3) Use the hexagon wrench to tighten the height adjustment bolt. Make sure that the pen carriage is parallel
to the writing panel.
(4) When the adjustment is complete, remove the height adjustment plate (thick) from under the pen
carriage.
Height adjustment during cutter pen installation
(1) Loosen the pen holder section screw and mount the pen.
(2) Insert the height adjustment plate (thin) under the pen and adjust the height.
(3) After mounting the pen, tighten the screw.
(4) When the adjustment is complete, remove the adjustment plate (thin) from under the pen.
CHECKPOINT
Always make sure that the writing panel is in a horizontal position before making this adjustment. When
cutting thick media, place the medium on the writing panel before making this adjustment.