Setting up The Cutter Plotter
2-7
(8) Move the stock shaft stopper to the LOCK position.
LOCK position:
This is the status when the lever has been pulled up and inserted into the groove, and the
silver-colored section can be seen. The stock shaft does not rotate in the LOCK status.
LOCK
FREE
CAUTION
While cutting or plotting is in
progress, please keep your
hands, hair, etc., away from
the shaft holder and the collar.
Black sticker
Silver-colored section
(9) When pulling the medium out of the cutting plotter, stand facing the front of the cutting plotter
and pull the center point of the medium's width toward you.
NG
NG
OK
(10) As shown in the figure below, pull on the medium at the front of the cutting plotter, so that the
medium's tension is equal at areas A and B.
A
B
(11) After confirming that the medium's tension is equal at both sides, raise the media set lever to
lower the push rollers and hold the medium in place.
