BURNING WOOD LOGS
As previously stated wood burns best
on a bed of its own embers which also
forms a barrier that reflects heat and
protects the fire grate from being
damaged. You can therefore leave a
bed of ash in place to create a layer of
approximately 25mm (1”), only
occasionally removing the surplus ash.
The end grain of the wood produces
more of the remaining moisture and
gases so whenever possible point the
log ends away from the glass to help
keep the glass clean.
Fuel Load
The logs should be
approximately 250mm (10”) with a
maximum diameter of 100mm (4”).
A typical fuel load should weigh
approximately 1.5kg (3.3lb).
To get the best out of your stove,
ideally you will need three different
thicknesses of wood log as you build
the fire through each lighting phase:
A Kindling
This is generally finely
chopped wood, approximately 5 to
10mm thick (1/4” to 1/2”) from your
supply of logs. Alternatively use dried
twigs or small branches which have also
been fully seasoned
B Lighting Logs
These are slightly
bigger diameter logs, approximately
25 to 50mm (1” to 2”)
C Refuelling Logs
These should be
approximately 75 to 100mm thick (3”
to 4”). Bigger logs should be split down
to this size
Lighting a Wood Fire
The main difference between smoke
and flame is temperature, so when
lighting a fire you need to get the
temperature in the firechamber as high
as possible as quickly as possible. This
is also critical in creating a good ‘draw’
within the flue system, especially when
it is particularly cold outside.
When flue gas temperatures are below
120°C, creosote tars form within the
gases and the fire will be smoky and
The recommended maximum fuel load: Photo
shows a typical loosely stacked fuel load of
approximately 1.5kg of fully seasoned wood logs
approx 250mm (10”) long by 75 – 100mm thick
A
B
C
16
