The machine is equipped with various
alarms.
Spray pipe motor alarm
If the spray pipes should become blocked
for any reason, the machine comes to a
total standstill and all the lamps on the con-
trol panel - begin to blink in time.
If the alarm goes off:
Switch the machine off by pressing the stop
button. Open the doors, check what has
caused the alarm and remedy the fault.
Then close the doors, select a new wash
programme and start the machine.
NB! Contact a service engineer if no fault is
found.
Long filling time
If it takes too long to fill the wash tank, the
lamp for emptying the wash tank blinks
out of time with the others. Check that
the water supply is switched on. Another
cause can be a block in the drain valve or a
false reading for the water level.
NB! If the
drain valve is blocked or there is a false level
reading, contact the service staff.
18
4.
Troubleshooting
and
alar
ms
Check the following if the utensils
are not completely clean:
·Are the spray nozzles blocked?
·Were the utensils located cor
rectly?
·Wasthe right programme selected?
·Is the wash water very dirty?
·Are there sufficient granules?
·Is the detergent dosing correct?
Long time after filling
If the washing with granules lamp blinks
out of time with the others, the most likely
problem is foaming in the machine.
NB! Contact the service staff to check that
the temperatures in the wash and rinse tanks
are correct. Check that washing-up liquid is
not being used in the machine. Contact your
detergent supplier to check if the detergent
dosing is correct.
Wrong temperature in the wash or rinse
tank
If either of the lamps under the symbols
for the wash water or rinse water
thermometers blinks out of time with
the others the thermostat is not working.
The machine cannot be started before the
thermostat has been replaced.
NB! Contact the service staff for a check.
1
10
2
5
9
10
3